Delo-ML DB136 Anaerobic and light curing adhesive 550ml/600g

DELO® ML DB 136 Anaerobic and light curing adhesiveFluorescent variant of DELO-ML DB135Low-viscous settingLight-curing and anaerobic-curingVisible adhesive in boundary areas can be cured with visible lightHigh strength, difficult to removeVery good strengths and low roughness depth of the bonding areasBaseModified urethane acrylateOne-component, solvent-freeDual-curing adhesiveCuringAnaerobic, i.e., by exclusion of air and under metal influence at room temperature with smallgapThe curing may be assisted by application of heat, use of activator and/or light, e.g. if the curingspeed is too slow or if it comes to larger gapsThe build-up of strength depends on the components and the geometry joined. The initialstrength is achieved after just a few minutes. Significant acceleration is possible by using anactivator and/or applying heatCuring with UV light in a wavelength range of 320 – 450 nm. DELOLUX LED curing lamps areespecially suitable as per the chart below. All standard DELOLUX HID discharge lamps arealso suitableWhen using light fixation, an intensity at the adhesive of 700 mW/cm² should not be exceeded.Application related, higher intensities can be usefulBoth curing mechanisms can be used in combination or separatelyField of applicationBonding: metals, small surfaces and with a high fitting accuracyFixing: coaxial components, e. g., bearings or socketsAdhesive leaking from the bonding gap can be cured in seconds with visible lightTherefore, firmness to touch can be reached fasterEasy application control due to fluorescent colorIf one of the components to be bonded is translucent, non-metals can also be bonded throughpolymerizationDELO curing lamps generating radiation adjusted to the adhesives are available to initiate thisreactionSuitable for small casting applications, if cured with DELO curing lamps. The top, openadhesive surface exposed to air remains tackyAlso suitable for the bonding of components with dissimilar coefficients of expansion due toflexibilized and tension-equalizing natureThe cured product is normally used in a temperature range of -60 °C to +180 °C; depending onthe application, other limits may be more reasonableTechnical specificationsColor: clear- yellowishPrefered clearance [mm]: 0,05-0,1Clearance with heat or activator [mm]: up to 0,3-0,4Clearance with light curing [mm]: 4Density [g/cm³] at room temperature (approx. 23 °C): 1.1Viscosity [mPas] Brookfield at 23 °C: 1200 thixCuring time until initial strength [min] at room temperature (approx. 23 °C), anaerobic on zinc-phosphated screws: 2-4 min Information on product safety (Manufacturer, Contact)DELO Industrie Klebstoffe GmbH & Co. KGaA, DELO-Allee 1, 86949 Windach, GERMANY, +49 8193 9900-0, , www.delo.de