Klüberbio AG 39-602 Adhesive lubricant for open gears 25kg

Klüber Klüberbio AG 39-602 Environmentally acceptable adhesive lubricant for open gears and steel cablesKlüberbio AG 39-602 contributes to long component life and good corrosion and wear protection.The finished product meets the biodegradability, minimally toxic and non-bioaccumulative standards established by the US EPA for the 2013 Vessel General Permit. Klüberbio AG 39-602 contains > 60 % of renewable raw materials.Temperature range: -20°C to +100°C Volume: 25kg bucketAlso available in: Cartridge 400g, Can 1kg, Drum 200kgBenefits for your applicationComplies with the requirements for Environmentally Acceptable Lubricants as defined in Appendix A of the 2013 Vessel General PermitReduced environmental impact in the event of discharge into water. The base oil is derived from renewable resourcesGood adhesion and water resistance for long relubrication intervalsSelected additives ensure longer component life and reduced wearCorrosion protection under seawater influence due to especially selected anti-corrosion additivesApplicationsKlüber Klüberbio AG 39-602 was developed for the lubrication of open pinion gears on winches and jack-up platforms, as well as steel cables in contact with water.The product can also be used in other maritime applications that require lubricants to have good water washout resistance, very good anti-corrosion resistance and/or good load-carrying capacity such as with low-speed plain bearings, guide rails and open winch gears.Application notesKlüber Klüberbio AG 39-602 can be applied continuously through transfer lubrication with pinion or by brush.Compressed-air lubrication equipment can be used for the lubrication of steel cables.Technical specificationsArticle number 009042Chemical composition, type of oil ester oilChemical composition, thickener calcium soapLower service temperature -20 °C / -4 °FUpper service temperature 100 °C / 212 °FColour space yellowTexture homogeneousTexture fibrousDensity at 20 °C approx. 0.97 g/cm³Worked penetration, DIN ISO 2137, 25 °C, lower limit value 290 x 0.1 mmWorked penetration, DIN ISO 2137, 25 °C, upper limit value330 x 0.1 mmKinematic viscosity of the base oil, DIN 51562 pt. 01/ASTM D-445/ASTM D 7042, 40 °Capprox. 600 mm²/sKinematic viscosity of the base oil, DIN 51562 pt. 01/ASTM D-445/ASTM D 7042, 100 °C approx. 85 mm²/sFlow pressure of lubricating greases, DIN 51805, test temperature: -20 °C <= 1 400 mbarDrop point, DIN ISO 2176, IP 396 >= 120 °C Information on product safety (Manufacturer, Contact)KLÜBER LUBRICATION MÜNCHEN GMBH & CO. KG, Geisenhausenerstraße 7, 81379 München, GERMANY, +49 89 7876 0, , www.klueber.com